Configuring Power Paramters:
----------------------------

Scsiport allows adapters to configure some power settings.

NeedsSystemShutdownNotification: DWORD
If nonzero, this value tells scsiport that the adapter needs to
have its AdapterControl routine called when a system shutdown
occurs.  See the section on request sense parameters below for the
location of this key.


Configuring Tunable Performance Parameters:
-------------------------------------------

Scsiport supports the following configurable perfomance parameters:

RemainInReducedMaxQueueState: DWORD
If set, this value indicates the number of seconds a logical unit will
remain in a degraded performance state in which its MaxQueueDepth has
been reduced due to one or more requests failed with QUEUE FULL status.
This value is read from ScsiPort's DeviceParameters key in the registry.
See the section on request sense parameters below for the location of
this key.


Configuring Request Sense Parameters:
-------------------------------------

Scsiport supports configurable request sense parameters on a per-adapter
basis.  The following parameters may be configured under the HBA's device 
entry:

TotalSenseDataBytes: DWORD [18..255]
If set, this value designates the size of the buffer Scsiport will allocate
for request sense data.  If the value is not set, the default size of 18 (0x12)
bytes is used.

RequestSenseTimeout: DWORD
If set, this value designates the timeout period for REQUEST SENSE commands, in
seconds.  If the value is not set, the default timeout value of 2 seconds
is used. 

SenseDataEventClass: STRING
This string value is a GUID that identifies a WMI event class.  If this value
is present, the port driver will generate a WMI event containing the request
sense data every time a REQUEST SENSE occurs.  The WMI event class must be
added into the repository for clients to find it.  See the DDK for the
ways this can be done.  One way is to use the MOF compiler, MOFCOMP...
    mofcomp -N:root\wmi scsiport.mof

HKLM
  System
    CurrentControlSet
      Enum
        <bus>
          <DeviceId>
            <Device>
              DeviceParameters
                ScsiPort
                  DWORD TotalSenseDataBytes=<18..255>
                  DWORD RequestSenseTimeout=<timeout in seconds>
                  DWORD RemainInReducedMaxQueueState=<duration in seconds>
                  DWORD NeedsSystemShutdownNotification=<0|1>
                  STRING SenseDataEventClass={GUID}

Example:
HKLM
  System
    CurrentControlSet
      Enum
        PCI
          VEN_9004&DEV_6178&SUBSYS_78619004&REV_03
            3&1b3e6122&0&5070
              DeviceParameters
                ScsiPort
                  TotalSenseDataBytes=0xff
                  RequestSenseTimeout=0xa
                  RemainInMaxQueueState=0x1e
                  NeedsSystemShutdownNotification=1
                  SenseDataEventClass={d69fad96-c9a3-4ed0-b98b-47c27feac68c}


Verifier:
--------

To enable the scsi verifier, add the following registry entry to the scsiport
control entry...

HKLM\system\currentcontrolset\control\scsiport
    Verifier
        VerifyLevel = <verifier level>

The following values control verifier behavior...
#define SP_DONT_CHK_HW_INITIALIZE_DURATION  0x80000000
#define SP_DONT_CHK_ACTIVE_UNTAGGED_REQUEST 0x40000000
#define SP_DONT_CHK_REQUESTS_ON_RESET       0x20000000

Also, from the debugger, setting SpVrfyLevel=0xffffffff will disable the 
verifier.